Using ADP-2x8-V with and ACM-16 to emulate dual 8 bit devices.
=======================================================================

1. The ADP-2x8-V is wired for EPROMs.  Configure the ACM-16 for EPROM.

2. You CAN however support FLASH devices up to 2Mbit each. If you need 
   to WRITE back to the emulator from the target side,
   connect an external wire from your target WRITE line to JP4-1
   on the ACM (WT).  You still set the ACM-16 for EPROM pinout.

3. This combination can only support 16bit WRITEs.  Your target will
   not be able to write to ONE socket only.

4. NOTE that the ADP-2x8-V parallels all of the DIP-32 signals except
   the data lines.  This includes all of the address lines and all
   of the control lines (OE,WT,CS).  The ADP-2x8-V can NOT support separate
   Chip selects or Output enables.

5. You may need to specify SWAP in the Quickloader or command line loader
   to reverse the ODD/EVEN spilt between the two 8 bit devices.

6. Be sure to specify a device size equal to the DOUBLE the size of the 
   emulated device.  For example, if you are emulating 2 - 1Mbit devices,
   tell the loader the device size is 2Mbit.

=========================================================================